What is the jumper setting for installing a DVD-RW as the second device on an IDE cable?

When installing a DVD-RW as the second device on an IDE (Integrated Drive Electronics) cable, the jumper setting of "Cable select" is appropriate. This mode allows the devices on the cable to determine their roles (master or slave) based on their position on the cable. The drive at the end of the cable typically becomes the master, while the drive in the middle connector is recognized as the slave.

Using cable select simplifies the configuration process since you don't manually set jumpers to designate which device is the master or slave. Instead, the IDE controller automatically identifies the devices based on their physical locations, reducing the chances of misconfiguration.

In contrast, setting the drive jumper to "Master" would imply that the DVD-RW is the primary device on the cable, which wouldn't be appropriate since it's intended to function as the second device. The other jumper settings, like "ID0" and "ID2," do not correspond to standard IDE configurations and thus would not be applicable in this scenario.